C1 and C2 are capacitors in parallel. C3 is in series with C12. C1=16.6 microF, C2=8.2 microF, C3=0.3 microF. A 1.52 V battery is connected in this combination. Find the charge stored...

C1 and C2 are capacitors in parallel. C3 is in series with C12. C1=16.6 microF, C2=8.2 microF, C3=0.3 microF. A 1.52 V battery is connected in this combination. Find the charge stored...

specifically on a breadboard, so no soldering involved in this question at all.

Show that maximum power generated in y when R = 3 ohm . Given that maximum power is calculated when y=5 ohm The link of circuit is in the topic http://i.imgur.com/DVwtE8p...

effect of current on resistance in series graphical explaination

An LR circuit having time constant of 50 ms is connected with an ideal battery of emf E . prove that the time elapsed before the power dissipated in heat reaches half its maximum value is 61ms

A resistor is placed in a circuit. The current in the circuit is 2 amperes and the voltage drop across the resistor is 8 volts. The voltage is then increased to 12 volts. What will be the new current...

In the given circuit the ammeter A1 and A2 are ideal and ammeter A3 has a resistance 1.9 x 10-3 . Then show that reading from ammeter are 82/27 , 34/27 & 0 respectively . The...

In the given circuit , all the capacitor are initially uncharged . After closing the switch S1 for a long time suddenly S2 is also closed for a long time . Then show that total heat produced after...

A cell of emf E having an internal resistance r is connected to an external resistance R . The potential difference V across the resistance R varies with R as shown in figure by which curve http://i...

A 3 mega ohm resistor and an uncharged 10^(-6) F capacitor are connected in a single loop circuit with a constant source of 4 volt . Show that at one second after the connection is made , the rate...

a. What is the current in a 40.0 Ω resistor that has a voltage drop of 14.0 V across it? b. What is the equivalent resistance of a 3.0 Ω resistor, a 6.0 Ω resistor, and a 4.0 Ω resistor connected...

How would a parallel circuit impact four identical light bulbs that were plaed in parallel with a six-volt battery? Explain what would happen please.

How would a parallel cicuit impact four identical light bulbs that are placed in parallel? Short but brief paragraph explaining why please.

How would a parallel circuit impact the circuit of three light bulbs had the battery replaced with a three-volt battery? Please explain what would happen.

How would a parallel circuit impact a circuit of three new light bulbs had a larger current with the original one-volt battery? Please explain what would happen.

The cell's electolyte consists of dilute sulphuric acid and two electrodes of unspecified materials.

round to the nearest 10th

Electrical appliances plug into the wall with a single plug, but a plug has at least two prongs (sometimes there is a third one, but the minimum is two). Why do you think that this is the case? Refer...

Two light circuits with identical lightbulbs. One has two lightbulbs in parallel. Other has them in series. Student 1 says series will glow brighter cuz the same current goes to both lightbulbs...

A circuit with a 100 ohm resistor, followed by a parallel wiring with two 100 ohm resistors. What happens to the potential difference along a parallel resistor if the other one is removed.

Steven R.

Ivy League SAT and ACT tutor

Livingston, NJ

4.8
(249 ratings)

Vaibhav S.

Law Student: Experienced Calculus and Science College and H.S tutor

New York, NY

4.9
(162 ratings)

Andrew L.

Educating, One Mind at a Time!

Valley Stream, NY

5.0
(201 ratings)